Laminations

Oak presses are in use around the world in a variety of lamination applications.

LP Series: 30-300 tons, Speeds up to 400 SPM

Structure

LP presses feature heavy duty cast iron frame construction for superior attenuation of shock and vibration.

Accuracy

• The patented Scotch Yoke slide of the LP series press includes a total of twelve (12) preloaded roller bearing assemblies.
  • Eight (8) bearing assemblies are installed near the material pass line to ensure the lateral positioning of the slide.
  • Four (4) additional bearing assemblies are installed above the drive shaft to counteract the effects of tipping forces created by tooling.

Hydraulic Withdrawal             

• The LP Series provides up to 12 inches of slide lift which greatly simplifies.
  • Material Lacing. (you can open die area without effecting shut height settings)
  • Tooling Inspection & Maintenance.
  • Replace tooling sections without removing die from press. (less downtime)

“Stuck-on-bottom” recovery: 

• Powerful hydraulic withdrawal system can "unstick" even severe jambs.
• No need to “bar” the press, reverse the drive motor, or loosen tie rods.
• Recover from slide stalls in seconds instead of hours.

Quick Change tooling 

• Withdrawal system powerful enough to lift the entire die set off the bolster.